Home

UNIROBO maker line Downloads

UNIROBO maker line Downloads

*.STL files for direct processing with a Slicer Software (recommendation Ultimaker Cura). For the statically important parts of a frame, we recommend an Infill of min. 35%, as well as the use of a Carbon Filament. But also Standard PLA works normally, if the thermal stress limits of the material are taken into accou...

UNIROBO maker line Downloads

*.STL files for direct processing with a Slicer Software (recommendation Ultimaker Cura). For the statically important parts of a frame, we recommend an Infill of min. 35%, as well as the use of a Carbon Filament. But also Standard PLA works normally, if the thermal stress limits of the material are taken into account and the highest possible stiffness of the supporting components is ensured. For very warm/hot running drive combinations (above 60°C), many of the filaments are not suitable! Please note when you purchase of the Filament for a drone project, the technical data of the product. For more information on this in our WiKi.

More

UNIROBO maker line Downloads There are no products in this category.