Home

Cube Kore for Pixhawk2.1 Cube

HX4-06038

New product

Cube Kore for Pixhawk2.1 Cube

More details

approximately 6-8 working days

224,00 € Tax included

Add to wishlist

Bequeme Zahlung
Bequeme Zahlung

More info

Cube Kore for Pixhawk2.1 Cube

New Version after V1.4

The Cube, Kore is a new Carrier Board of ProfiCNC/HEX. The Cube, Kore integrates all the interfaces of the Standard Carrier Boards and is for use with the Pixhawk2.1 Cube, and future versions of the Cubes provided.

The construction of a Multicopter, and, of course, other vehicle types, to be facilitated by the use of the Cube Kore Carrier Boards is enormous. The integrated Power Distribution Board (power distribution) is already equipped with a current Sensor and a total of 50V and a max. approx. 140 a load.

Built-in Step-Down Module for 5V and 12V consumers (e.g., Gimbal, FPV Equipment and more, additional Payload) to simplify the wiring and reduce overall cable clutter.

In addition, each of the 4 corners Lötplatten for the ESC power supply, and pin strips for the Signal cables of the ESC's. The manufacturer has thought in these areas also on a 12V supply for the LED.

The product is the Carrier-Board Cube Kore - a Pixhawk2.1 Cube is not included in the scope of delivery.

All Features at a glance:

- Up to 12-cell Lithium battery (50,4 V)
- Can withstand up to 140A continuous current short-time load peaks of up to 280A
- Connections for the power supply and the RC Signal for ESCs in the corners
- 12V navigation light power at each corner available, built-in power distribution
- Built-in Sensor for voltage (V) and amperage (A)
Redundant Layout for flight critical components
Load plug - in connector with resettable Fuses for 5V, 12V and direct battery supply
- LED indication for power OK or is a Problem/error
- Built-in Buzzer with volume control
Connectors for each function of the Pixhawk2.1 The Cube
- Easily accessible PWM voltage selection switch (3.3 V or 5 V)
- Resistance to mass Bouncing to the PWM Signal
Connector compatible with Standard ProfiCNC Carrier Board

Connector Ports for debugging IO, and FMU

Cable, Standard

  • 4-wire JST-GH
  • 6-wire JST-GH

Cable for the power supply of the Payload (devices such as a Gimbal, FPV transmitter, etc.)

  • Clik-Mate, 4-wire, 1.25 mm, 5V consumer
  • Clik-Mate, 5-wire, 1.25 mm, for 12V consumers
  • Clik-Mate, 6-wire, 1.25 mm, for use in the voltage of the main circuit (LiPo)

Scope of delivery:

1x Cube Kore

Reviews

No customer reviews for the moment.

Write a review

Cube Kore for Pixhawk2.1 Cube

Cube Kore for Pixhawk2.1 Cube

Cube Kore for Pixhawk2.1 Cube

Accessories

Customers who bought this product also bought:

16 other products in the same category: